 DIMM2GBND3K: €18.91
Listino Pubblico GENNAIO N. 1 del 07.01.2016
|
|
KINGSTON 2GB DDR3 1333 (KVR13S9S6/2)
DESCRIPTION
This document describes ValueRAM's 256M x 64-bit (2GB)
DDR3-1333 CL9 SDRAM (Synchronous DRAM) 1Rx16, memory
module, based on four 256M x 16-bit FBGA components. The
SPD is programmed to JEDEC standard latency DDR3-1333
timing of 9-9-9 at 1.5V. This 204-pin SODIMM uses gold
contact fingers. The electrical and mechanical specifications
are as follows:
FEATURES
•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
•VDDQ = 1.5V (1.425V ~ 1.575V)
•667MHz fCK for 1333Mb/sec/pin
•8 independent internal bank
•Programmable CAS Latency: 9, 8, 7, 6, 5
•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•8-bit pre-fetch
•Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•Bi-directional Differential Data Strobe
•Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•On Die Termination using ODT pin
•Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE
< 95°C
•Asynchronous Reset
•PCB : Height 1.180” (30.00mm), single sided component
SPECIFICATIONS
CL(IDD) : 9 cycles
Row Cycle Time(tRCmin) : 49.125ns (min.)
Refresh to Active/Refresh : 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) : 36ns (min.)
Maximum Operating Power : 1.050 W*
UL Rating : 94 V - 0
Operating Temperature : 0°C to 85°C
Storage Temperature : -55°C to +100°C
*Power will vary depending on the SDRAM used. |
|
